disktest

by Chris Kranz on Mar.03, 2009, under Maintenance Mode Commands

*> disktest
SEQUENTIAL_ALTERNATING using [1024kb I/O - timeout: 300s queuedepth: 3 ] — Max LBA Range 6MB

disktest: will use both A and B loops for FC disks.
Disks selected: 0b.20 0b.19 0b.18 0b.17 0b.16
This test will take about 5 minutes to complete.

disktest performs reads and writes to the savecore area of
the selected disk(s). Ensure savecore has been run prior
to executing disktest to avoid losing a corefile.

Do you wish to continue?

VN:F [1.9.11_1134]
Rate this post:
Rating: 0.0/10 (0 votes cast)

:, , ,

Leave a Reply

Bad Behavior has blocked 1095 access attempts in the last 7 days.

© 2009-2012 Chris Kranz All Rights Reserved
This site is not affiliated or sponsored in anyway by NetApp or any other company mentioned within.